Dynomotion

Group: DynoMotion Message: 12584 From: daveymahomh600e Date: 12/10/2015
Subject: Power Requirement for Kanalog / KFlop Boards
Hello Folks,

I have a new KFlop/Kanalog stack and was wondering what size of 5V power supply is typically needed to run it?

The plan is to use 0-10v output for 3 servo drives and measure analog input from 2 of those drives (for current usage feedback).

Thanks in advance,
David.
Group: DynoMotion Message: 12585 From: TK Date: 12/10/2015
Subject: Re: Power Requirement for Kanalog / KFlop Boards
Hi David,

2Amps or 10W or more of +5V should be more than enough.

Regards
TK

On 12/10/2015 4:39 PM, david.m.stevenson@... [DynoMotion] wrote:
 

Hello Folks,

I have a new KFlop/Kanalog stack and was wondering what size of 5V power supply is typically needed to run it?

The plan is to use 0-10v output for 3 servo drives and measure analog input from 2 of those drives (for current usage feedback).

Thanks in advance,
David.
Group: DynoMotion Message: 12586 From: David Stevenson Date: 12/10/2015
Subject: Re: Power Requirement for Kanalog / KFlop Boards
Hi Tom,

Thanks very much for the quick response! I would expect that input power requirements are based upon how much analog output is needed from Kanalog?

Best regards,
David.

On 2015-12-10 7:42 PM, TK tk@... [DynoMotion] wrote:
 

Hi David,

2Amps or 10W or more of +5V should be more than enough.

Regards
TK

On 12/10/2015 4:39 PM, david.m.stevenson@... [DynoMotion] wrote:
 

Hello Folks,

I have a new KFlop/Kanalog stack and was wondering what size of 5V power supply is typically needed to run it?

The plan is to use 0-10v output for 3 servo drives and measure analog input from 2 of those drives (for current usage feedback).

Thanks in advance,
David.




This email has been sent from a virus-free computer protected by Avast.
www.avast.com
Group: DynoMotion Message: 12587 From: Steve Klemp Date: 12/11/2015
Subject: Re: Power Requirement for Kanalog / KFlop Boards
http://www.mouser.com/ProductDetail/Mean-Well/RS-25-5/?qs=sGAEpiMZZMsPs3th5F8koAOKs67AukcKlkybHUmpr2I%3d

David. This is a very good option.

Group: DynoMotion Message: 12588 From: David Stevenson Date: 12/11/2015
Subject: Re: Power Requirement for Kanalog / KFlop Boards
Thanks Steve!

On 2015-12-11 4:00 AM, Steve Klemp steveklemp@... [DynoMotion] wrote: